PAS 8812:2016 Temporary works - Application of European Standards in design - Guide

Standard Number
PAS 8812:2016
Title
Temporary works - Application of European Standards in design - Guide
Publication Date
Descriptors
PAS 8812 helps designers select the most appropriate standard to adopt when planning temporary works. This is in relation to the transfer of key design data and information across all phases of the design cycle. It includes recommendations on suitable partial factors and combination of actions, guidance on appropriate analysis approaches, the reuse of equipment, the relationship between Eurocodes and other related standards and clarification of design requirements for identified groups of temporary works. NOTE: BS PAS 8812:2016 gives guidance on the application of European Standards to the design of temporary works in the UK when adopted voluntarily, required by the Public Procurement Directive [2] or stipulated by the client. See also PAS 8811, Temporary works - Client procedures - Code of practice.
Keywords
Safety measures, Structural design, Loading, Temporary structures, Scaffolding components, Construction equipment, Performance, Scaffolds, Occupational safety, Wind loading, Facades, Design calculations, Structural systems
Pages
64
File Size
26.3 MB
Download file

CONTENTS

  • Foreword
  • 0 Introduction
    • 0.1 Definition of temporary works
    • 0.2 Categories of temporary works
    • 0.3 Typical features of temporary works and associated risks
    • 0.4 Continuity in best practice
    • 0.5 European Standards for temporary works design
  • 1 Scope
  • 2 Normative references
  • 3 Terms, definitions and symbols
    • 3.1 Terms and definitions
    • 3.2 Symbols
  • 4 Designing temporary works to the Eurocodes
    • 4.1 Scope of application
    • 4.2 Basic requirements
    • 4.3 Design situations
    • 4.4 Actions
    • 4.5 Limit state design
    • 4.6 Methods of analysis
    • 4.7 Verifications
    • 4.8 Stability of structural systems
    • 4.9 Friction
    • 4.10 Use of proprietary equipment
    • 4.11 Off site manufacture
  • 5 Materials
    • 5.1 General
    • 5.2 Design values of material or product properties and resistances
    • 5.3 Specific considerations for steel and aluminium
  • 6 Specific design requirements for identified groups of temporary works
    • 6.1 Group 1 - Falsework, formwork, access and protection
    • 6.2 Group 2 - Geotechnical
    • 6.3 Group 3 - Vehicle and pedestrian bridges and related works
    • 6.4 Group 4 - Underground
    • 6.5 Group 5 - Marine
    • 6.5 Group 6 - Other
  • Annexes
    • Annex A Reference publications for temporary works
    • Annex B Clarification of key terms and definitions for the design of temporary works to the Eurocodes
    • Annex C Combinations of actions and partial factors for the design of temporary works to the Eurocodes
    • Bibliography